13 / 40
Hakki Pilke 38 Pro
Translation
Version 3
faulty equipment.
Connect the power cable for the electric
controls (in Figure 14) to the 12 V, 3-pin
socket for a work machine.
Figure 12.
When using the cardan shaft, observe any instructions provided by the manufacturer of the shaft. The
machine requires 25 hp of power, which must be taken into account with regard to the capacity of the cardan
shaft. A suitable cardan shaft is of power class four. Check that the shaft is properly locked to the splined shaft
of the angle transmission. Connect the chain that prevents the turning motion of the guard to hole B. Hang
the cardan shaft from hook C when the machine is not being operated and when it is disconnected from the
tractor. Finally, ensure that all connections are safe and secure. Never use a damaged or unprotected cardan
shaft.
Note! Tractor-powered machines must be attached to the lifting equipment of the tractor.
Note! The starter (Figure 15) only functions when the machine is powered by electricity.
3.2.2.
Electrical drive
An electric-powered machine
is powered by a 10 kW
electric motor. The IP value
of the electric motor is 55.
The fuse must be at least
25 A. The electrical cable
must be at least 5 x 4 mm²,
recommended
maximum
length is 30 m. In order to
connect the cable at the
combi
machine,
move
protective cover B of socket
A and the angle gear and
secure it into a position
where it covers the multiplier
gear, as in Figure 13.
In an electrically-powered
machine, the power cable of
the
electric
control
is
connected to the socket on
the side of the machine.
Figure 13. The machine’s electrical drive
