Managing the Encoder
Configuring the Video Settings
Makito User’s Guide, v2.1.0, Issue 01
73
Color Space
Makito-DVI
only
Auto
(Optional) Select the color space to use while
capturing the content. Matching the encoder
input color space to the source enhances
and optimizes color reproduction. This is
useful with source formats such as graphics
cards outputting HDTV resolutions. Select
either:
•
Auto:
The encoder determines the
appropriate color space to use.
•
YCbCr:
Forces the encoder to use
Y,Cb,Cr
•
RGB (Full Range):
Forces the encoder to
use RGB Full Range [
0..255
]
•
RGB (Limited Range):
Forces the
encoder to use RGB Limited Range
[
16..235
]
Aspect Ratio
Standard
Definition only
Auto
Specifies the aspect ratio of the video source
and signals it into the MPEG stream:
•
WSS/AFD:
Aspect ratio is extracted from
the incoming video source based on WSS
(Wide Screen Signaling) or AFD (Active
Format Description) if detected.
•
Auto:
Aspect ratio is derived from the
incoming video source resolution.
•
16:9:
Aspect ratio is forced to 16:9.
•
4:3
: Aspect ratio is forced to 4:3.
NOTE:
WSS is only supported with analog
PAL video; AFD is only supported with SD-
SDI video.
Display Logo
Disabled
(Optional) Check this checkbox to enable a
pre-configured logo overlay. This option is
not available if no logo has been configured.
NOTE:
To configure the logo, see
HDCP Copy
Protection
Makito only
n/a
(Read-only) Indicates whether an HDCP
stream is copy-protected. If Yes, the stream
will not be encoded.
Total Load
n/a
The usage of the video encoding processor
in percentage %.
IMPORTANT:
When configuring HiLo
streaming, make sure the Total Load does
not exceed 100%. For supported HiLo
video encoding resolutions, see
Video Setting
Default
Description/Values (Continued)
