Haivision F-MB21B-R, User Manual

Page: 354 / 420

CLI Command Reference
stream
Makito X User’s Guide, v2.2, Issue 02 354
stillimage n/a
(Optional) Specifies the filename of a static
image that will replace the “real” video stream
when streaming is paused.
NOTE:
The static image file must already
have been converted into a file containing an
encoded single H.264 GOP sequence. You
can either use the
mkstill command, or the
Web interface
S
TILL
I
MAGES
page
(
see
“Configuring Still Image Streaming” on
page 166).
Still Image insertion when pausing a stream is
not
supported when a HEVC/H.265 video
encoder is selected as a content source.
shaping no
(Optional) To enable Traffic Shaping for the
stream, specify
shaping=yes
.
For some limited networks such as satellites
or some dedicated network pipes, it may be
necessary to enable Traffic Shaping to
smooth the traffic and respect the absolute
upper limit configured.
NOTE:
Using Traffic Shaping on streams
above 7Mbps will create audio/video artifacts.
ceiling n/a
(Optional, shaping must be
yes
) The
percentage of network bandwidth beyond the
average rate that the encoder is allowed to
use if needed. This is used to set the ceiling
bandwidth range.
5..100%
, default =
15
NOTE:
To configure the ceiling percentage
for CBR streams with metadata, see
“Bandwidth Overhead for CBR Streams with
Metadata”
on page 132.
idlecells no
(Optional, shaping must be
yes
) When
enabled, Idle TS cells will be inserted into a
TS stream when necessary.
yes,no
delayaudio no
( shaping and idlecells must be
yes
) When
enabled, delays the transmission of audio
information to prevent MPEG-2 TS HRD main
buffer overflows. Per reference decoder main
audio buffer defined in IEC/ISO 13818-
1/H.222.0.
yes,no
Parameter Default (Cont.) Description/Values (Cont.)