vario flex
Commissioning
Order h49 7144.907-333
37
NOTE
Damage to materials caused by contaminated /
unprocessed cooling lubricants!
For the product to function properly, in particular
for internal flushing with cooling lubricants and/or
when using tools with internal flushing, ensure
that the cooling lubricant is cleaned / processed,
and that it contains no particles measuring >100
microns [filtered with a mesh width of 100 mi-
crons].
NOTE
Damage to seals caused by using the wrong cool-
ant lubricants!
To clean the product, never use a cooling lubri-
cant that attacks and damages the sealing ele-
ments installed. Those installed sealing elements
can be made of NBR, Viton and PUR materials.
Never use cooling lubricants that contain ester or
a polar solvent.
8.2 Tests
NOTE
Serious damage to, or destruction of, the machine
tool and the workpiece caused by damaged, in-
complete or incorrectly installed products!
Only install undamaged and complete products
properly.
If in doubt, contact the manufacturer.
Assure the following points before every installation and/or
before every time the products are put into service:
The products used are undamaged.
All fixing screws are present on the products, and are
tightened to the correct tightening torque.
None of the edges and races are chipped or show any
signs of wear.
The speed set on the machine tool must not exceed the
maximum speed of the product. Always take the lowest
value of all maximum speeds for combined products in-
dicated.
Do not exceed the maximum technical data indicated on
the product.
All installation tools are removed from the machining
area.
Clamping device and workpiece are compatible.