TESTit
Faults
116
Order h49 7144.907-333
Fault
Possible cause
Remedial action
Remedied by
TESTit software
displays a
measuring force
although no
measurement is
being performed
Measuring device
was overloaded
during a previous
measurement
TEST module must be recali-
brated
HAINBUCH
Measuring device
is damaged
Measuring device
dropped / struck
Functional test at the factory; If
necessary, components must be
replaced
HAINBUCH
Table 13: Fault table
12.3 Reseting the IT module
In rare cases, it is necessary to restart the IT module. This
restart is performed by means of the reset button.
INFORMATION
The Reset button can be reached with a suitable tool
through the 1.5 mm hole.
1. Press the Reset button.
If the LED lights up green, the restart of the IT module has
been performed successfully.
If the LED does not light up, the charge level of the IT mod-
ule's rechargeable battery may be too low. The IT module
must then be recharged.
