13
Instructions for Dissembling and Assembling
1. Instructions for after-sale service
●
Be sure to switch off the power in dissembling or repairing.
●
In connecting the conductor wires, be sure to use the insulated crimp
connecting terminals and box and crimp the wire to reliable position.
●
In welding the components, remember to twist the wire first, then weld and
insulate it to the switches with the iron.
●
In welding the wires with iron, do not touch the resin and insulated parts of the
switches with the iron.
●
The wires shall not touch the moving parts like the belt, motor pulley brake rod.
the sharp edges and the parts with high temperature.
●
If the wires have metal part, the wires shall not touch the metal directly.
Insulator shall be used between them.
●
After assembling, perform water inlet, washing and spinning. Every part shall
act normally. Confirm if the leakages, sound and vibration are normal.
2. Dissembling and assembling of the control panel components
Loosen the fastening screws. Move along the directions indicated in the figure to
dissemble the control panel. In installation, the beard shall be locked into the
insulation holes of the water reception groove and the spinning tub frame.
3. Dissembling and Assembling of the components of the spinning tub
frame
Dissemble the control panel. Loosen the two fastening screws at the rear of the
spinning tub frame, and then the spinning tub frame will be dissembled.
4. Dissembling and Assembling of the spinning tub
Dissemble the spinning tub frame and the fastening screw of the spinning tub
axle, and then the spinning tub can be taken out. In installation, the protruding
part of the brake wheel inner lining shall be imbedded into the groove on the
spinning tub axle.