![background image](http://html.mh-extra.com/html/haier/tv-8888-03/tv-8888-03_service-manual_138219009.webp)
9
damage caused by static electricity
1) Immediately before handling any semiconductor component or semiconductor-
equipped assembly, drain off any electrostatic charge on your body by touching a
known earth ground. Alternatively, obtain and wear a commercially available
charging wrist strap device, which should be removed to prevent potential
shock, prior to applying power to the unit under test.
2) After removing an electrical assembly equipped with ES devices, place the
assembly on a conductive surface such as aluminum foil, to prevent electrostatic
charge buildup or exposure of the assembly.
3) Use only a grounded-tip soldering iron to solder or unsolder ES devices.
4) Use only an anti-static type folder removal device. Some solder removal devices
not classified as “anti-static” can generate electrical charges sufficient to damage
ES devices.
5) Do not use freon-propelled chemicals. These can generate electrical charges
sufficient to damage ES devices.
6) Do not remove a replacement ES device from its protective package until
immediately before you are ready to install it. (Most replacement ES devices are
packaged with leads electrically shorted together by conductive foam, aluminum
foil or comparable conductive material).
7) Immediately before removing the protective material from the leads of a
replaced ES device, touch the protective material to the chassis or circuit
assembly, into which the device will be installed.
CAUTION:
Be sure no power is applied to the chassis or circuit, and observe all other safety
precautions.
8) Minimize bodily motions when handling unpackaged replacement ES devices.
(Otherwise even some normally harmless motions such as mutual brushing of
your clothes’ fabric or lifting of your foot from a carpeted floor might generate
static electricity sufficient to damage an ES device.)
General Soldering Guidelines
1. Use a grounded-tip, low-wattage soldering iron and appropriate tip size and shape
that will maintain tip temperature within the range of 500 °F to 600 °F.
2. Use an appropriate gauge of RMA resin-core solder composed of 60 parts tin/40
parts lead.
3. Keep the soldering iron tip clean and well tinned.
4. Thoroughly clean the surfaces to be soldered. Use a mall wire bristle (0.5 inch, or
1.25cm) brush with a metal handle. Do not use freon-propelled spay-on cleaners.
5. Use the following unsoldering technique
a. Allow the soldering iron tip to reach normal temperature. (500 °F to 600 °F)
b. Heating the component lead until the solder melts.
c. Quickly draw the melted solder with an anti-static suction-type solder removal
device that has solder braid.
CAUTION:
Work quickly to avoid overheating the circuit board printed foil.
1) Use the following unsoldering technique
a. Allow the soldering iron tip to reach normal temperature. (500 °F to 600 °F)
b. First, hold the soldering iron tip and solder the strand against the component lead
until the solder melts.
Summary of Contents for TV-8888-03
