Haier RF-8888-279, Service Manual

Page: 18 / 28

18
Knocking sounds from inside the compressor indicates that a large quantity of moist
refrigerant vapor or refrigerating oil has leaked into the compressor cylinder.
Striking sounds from metal parts inside the compressor indicate that moving parts are
loose.
Listen to the gas flowing in the evaporator by opening the refrigerator door while the
compressor is in operation. Normally, refrigerant circulating in the evaporator produces a
gentle whistling accompanied by a sound similar to water flowing. If only the whistling can
be heard and there is no sound similar to water flowing, then the refrigerant has already
percolated. If neither sound can be heard, the filter or capillary is clogged.
Touch and Feel
Feel the compressor while it is running. Its temperature should be less than 194ºF. Its
temperature may exceed 194ºF if it has been running for an extended period.
After the compressor has operated for 5~10 minutes, feel the condenser. The temperature
of its upper part should be higher than that of its lower part (or its right part is hotter than
its left part, depending on the type of condenser coil). This indicates that the refrigerant is
circulating properly. If the condenser is not hot, then the refrigerant is leaking. If the
condenser is hot for only a few minutes and then cools down, the filter and capillary are
clogged. If hot air is blown out of the forced air-cooling condenser, the system is out of
order.
Feel the filter’s temperature. Normally, the temperature on the filter’s surface should be a
little higher than the ambient temperature. If the filter is lower than the ambient
temperature, then the meshes of its screen are clogged. This obstructs the flow of
refrigerant and causing a drop in temperature due to throttling.
Feel the temperature of exhaust gas from the refrigerating system. The exhaust gas should
be extremely hot. If the refrigerator has an enclosed compressor refrigerating system, there
should be no frost or condensation on the gas suction tube. However, frost and
condensation may appear for a very short time period when immediately after starting the
machine.
Do not use only one of the indicators from the checklist above to decipher the state of your
refrigerating system. It is advisable to find out two or more abnormal phenomenon, or
conduct comprehensive troubleshooting because several kinds of troubles may share a
common abnormality.
ANALYSIS OF TROUBLES AND TROUBLESHOOTING
Poor Refrigerating Effect
The “poor refrigerating effect “refers to when the refrigerator operates normally, but does
not cool to the temperature indicated by the thermostat. Possible causes are discussed and
analyzed below:
Refrigerant leaks