14
31-7000110 Rev. 1
Installation Instructions
Place the blower unit back into the opening.
CAUTION
Do not pull or stretch the blower
unit wiring. Make sure the wires are not pinched.
1
6
5
ADAPTING BLOWER FOR
RECIRCULATION
(continued)
A4.
Replace blower motor screws removed in Step 2.
Slide cover plate into position on the back of the unit.
Replace blower plate and screws removed in Step 1.
Attach second cover plate on blower plate (including
one screw).
Cabinet Front
Cabinet Bottom Shelf
Filler Block
Oven Top
Equivalent to
Depth of Cabinet
Recess
2 Rotate front of oven up
against cabinet
bottom.
MOUNT THE OVEN
A5.
FOR EASIER INSTALLATION AND PERSONAL SAFETY,
WE RECOMMEND THAT TWO PEOPLE INSTALL THIS
OVEN.
IMPORTANT: Do not grip or use handle
during installation.
NOTE: If your cabinet is metal, use the nylon
grommet around the power cord hole to prevent cutting
of the cord.
NOTE: We recommend using filler blocks if the
cabinet front hangs below the cabinet bottom shelf.
IMPORTANT: If filler blocks are not used,
case damage may occur from over tightening
screws.
NOTE: When mounting the
oven, thread power cord
through hole in bottom of
top cabinet. Keep it tight
throughout Steps 1–3. Do
not pinch cord or lift oven
by pulling cord.
Lift oven, tilt it
forward and hook
slots at back bottom
edge onto two lower
tabs of mounting plate.
Self-Aligning Screw
Blower Plate
Back of
Oven
Blower
Plate
Screws
Blower Motor Screws
Cover Plate
Cover Plate
