Haier QDT125SSKSS, Owner'S Manual

Page: 15 / 20

49-55107
15
Problem Possible Cause What To Do
Detergent left in
dispenser cups Dishes or utensils are
blocking the detergent cup 5HSRVLWLRQWKHGLVKHVVRWKHZDWHUIURPWKHORZHUVSUD\
arm can flush the detergent cup. See the Loading
section.
5HSRVLWLRQWKHWDOOXWHQVLOVRUKHDY\VLOYHUZDUHWKDWPD\
be keeping the dispenser cup door from opening. See
the
Loading section.
Don’t place large bowls or pots directly under the
detergent dispenser.
Black or gray marks
on dishes Aluminum utensils have
rubbed against dishes
5HPRYHPDUNVZLWKDPLOGDEUDVLYHFOHDQHU
Dishes don’t dry Low inlet water temperature Make sure inlet water temperature is at least 120°F.
Select a cycle that includes heated dry such as
HEAVY
or NORMAL .
Rinse agent dispenser is
empty Check the rinse agent dispenser and fill as required.
Control panel
responded to inputs
but dishwasher
never filled with
water Door may not be completely
closed Make sure the door is firmly closed.
Water valve may be turned
off Make sure water valve (usually located under the sink) is
turned on.
Stained tub interior White film on inside
surface— hard water
minerals Haier recommends using rinse aid to help prevent hard
water mineral deposits from forming.
5XQGLVKZDVKHUZLWKFLWULFDFLGWRUHPRYHPLQHUDO
GHSRVLWV&LWULFDFLG3DUWQXPEHU:';FDQEH
RUGHUHGWKURXJK*($SSOLDQFHV3DUWV6HHEDFNFRYHU
for ordering information. Alternatively, purchase Lemi
6KLQH3DUW1XPEHU:';DQGIROORZWKH
directions on the label.
Dishwasher won’t
run Fuse is blown or circuit
breaker is tripped 5HSODFHIXVHRUUHVHWFLUFXLWEUHDNHU5HPRYHDQ\RWKHU
appliances from the circuit.
Power is turned off In some installations, the power to the dishwasher is
provided through a wall switch, often located next to the
disposer switch. Make sure it is on.
Reboot your control Turn off power to the dishwasher (at circuit breaker or
wall switch) for 30 seconds, then turn back on.
Control panel lights
go off when you’re
setting controls Time too long between
touching of selected pads If the control panel lights go off, touch any pad again and
continue setting controls.
Water standing in
the bottom of the
tub Air gap is clogged Clean the air gap. See the Care and Cleaning section.
High drain loop or air gap
not installed
5HIHUWRWKH,QVWDOODWLRQ,QVWUXFWLRQVIRUSURSHUGUDLQOLQH
installation.
Water won’t pump
out of the tub Drain is clogged If you have an air gap, clean it. See the Care and
Cleaning section.
If the dishwasher drains into a disposer, run disposer
clear.
Check to see if your kitchen sink is draining well. If not,
you may need a plumber.
Troubleshooting Tips... Before you call for service
TROUBLESHOOTING TIPS