Haier QDP555 Series, Owner'S Manual

Page: 21 / 72

49-4000207 Rev 0
21
ENGLISH
TROUBLESHOOTING TIPS
Problem Possible Cause What To Do
Detergent left in
dispenser cups
Dishes or utensils are
blocking the detergent cup
Reposition the dishes, so the water from the lower spray arm
can flush the detergent cup. See the LOADING section.
Reposition the tall utensils or heavy silverware that may
be keeping the dispenser cup door from opening. See the
LOADING section.
Don’t place large bowls or pots directly under the detergent
dispenser.
Black or gray marks
on dishes
Aluminum utensils have
rubbed against dishes
Remove marks with a mild, abrasive cleaner.
Dishes don’t dry Low inlet water temperature Make sure inlet water temperature is at least 120°F.
Select
Dry .
Use Temp .
Select a higher cycle, such as Sanitize .
Rinse agent dispenser is
empty
Check the rinse agent dispenser and fill as required.
Additional drying time is
needed
Leave door closed after the Clean light appears to allow the fan
to run an additional 90 minutes.
Note: If you open the door, this fan extension will be cancelled.
Control panel
responded to inputs
but dishwasher never
filled with water
Door may not be completely
closed
Make sure the door is firmly closed.
Water valve may be turned off Make sure water valve (usually located under the sink) is turned
on.
Flood float may be stuck Remove Ultra-Fine filter and lightly tap the piece under the
ultra fine filter that looks like a salt shaker. Replace the filter.
Stained tub interior White film on inside surface—
hard water minerals
Haier Appliances recommends Finish® Jet-Dry® Rinse Aid to help
prevent hard water mineral deposits from forming.
Run dishwasher with citric acid to remove mineral deposits. Citric acid
(Part number: WD35X151) can be ordered through Haier Appliances
Parts. See back cover for ordering information. Alternatively,
purchase Finish® Dishwasher Cleaner and follow the directions on
the label.
Dishwasher won’t run Fuse is blown or circuit
breaker is tripped
Replace fuse or reset circuit breaker. Remove any other
appliances from the circuit.
Power is turned off In some installations, the power to the dishwasher is provided
through a wall switch, often located next to the disposer
switch. Make sure it is on.
Control panel is locked Unlock control panel. See the Getting started section.
Proper Start sequence was
not followed
See the Using the dishwasher section.
Control panel lights
go off when you’re
setting controls
Time too long between
touching of selected pads
Each pad must be touched within 30 seconds of the others. To
relight, touch any pad again or open the door and unlock.
Water standing in the
bottom of the tub
Air gap is clogged Clean the air gap. See the CARE AND CLEANING section.
High drain loop or air gap not
installed
Refer to the Installation Instructions for proper drain line
installation.
Water won’t pump
out of the tub
Drain is clogged If you have an air gap, clean it. See the CARE AND CLEANING
section.
If the dishwasher drains into a disposer, run disposer clear.
Check to see if your kitchen sink is draining well. If not, you may
need a plumber.