Haier solar water heater
15
FAQ
It is Prohibited to disassemble, repair, maintain and reform the water heater by the non-
professional personnel. The improper method may cause serious injury or property damage.
If any failure takes place, contact the after-sales service department of Haier.
Phenomenon
The events to be confirmed
No water
Whether the water stops or the water
pressure is too low?
Contact the water
supply department for
the confirmation and
maintenance
Whether the water use point is blocked or
the water valve is opened?
Clean the block material
and open the water valve.
Cold water
Whether the water temperature is
controlled properly?
Adjust it again.
Whether the temperature controller of the
solar station is out of control?
Contact the after-sales
service department
The temperature of the
storage water tank doesn’t
rise.
The sunlight is not enough.
Use the electric heating
method.
The pipe heater is damaged.
Contact the after-sales
service department
The anti-freezing fluid is not enough.
Fail to start the equipment
It is not powered on, the power supply
socket is not switched on or the control
panel is damaged.
Display the failure code
The line is failed and there is the leakage
for the system.
Display the failure code
The storage water tank is not full with
water, the pipe heater is dry or the artificial
operation of the storage water tank sensor
detector causes the temperature rise too
quickly within a short time.
Display the failure code
The temperature sensor of the solar
collector is damaged.
Display the failure code
The temperature sensor of the storage
water tank is damaged.
A great deal of water flows
out from the temperature
pressure valve.
The pressure of the tap water source is too
high (greater than 0.70Mpa)
The water flow is not
constant in volume and
temperature.
The pressure of the tap water source is not
stable
Contact the water
supply department for
the confirmation and
maintenance
FAQ
