Service Manual
Model No:FCD-JTSA80-III
-5-
2-3. Dimensions
Chapter 3: Installation
3-1. Accessory parts
3-2. Installation
1. Installation must be made by installers of or designated by our company after-service department.
The water heatershall be wall-mounted.
2. Before installation, make sure water heater rear wires are fit firmly. Determine an installation location.
Make four holes
φ
12mm, 65 mm deep in the wall with an impact drill according to installating dimension.
Insert fixexpansion hooks and expansion bolts in corresponding wall holes. Lift the water heater. Insert
wall rack onto the hooks and bolts. Fit flat washers, rear wires and nuts in turn onto the bolts (see
Figure 2). Tighten the nuts and check them firm. Install accessories such as safety valve, drain hose as
shown in Figure 3. Use sealing compound to prevent water leakage.
3. To facilitate installation and removal, it is suggested a G 1/2" movable nut is fitted at appropriate
locations on inlet and outlet pipes respectively. Find water supply location. Connect inlet pipe, outlet
pipe and city water pipe respectively to the use point.
4. The hot water pipe shall not be too long to reduce the heat losses.
5. Please reserve some space in installation for the future maintenance.
Part Name
Qty
Product Model
Electic
water
heater
Safety
valve
Expansio
n bolt
Expansio
n hook
User’s
manual
Drain
hose
FCD-JTSA50-III 1
1
2
2
1
1
FCD-JTSA60-III 1
1
2
2
1
1
FCD-JTSA70-III 1
1
2
2
1
1
FCD-JTSA80-III 1
1
2
2
1
1
Summary of Contents for Little Sea-ox FCD-JTSA50-III
Page 10: ... 10 Sincere Forever ...
