Service Manual
Model No:
Issue
Rev.
16
Service Manual
Chapter 6: MAINTENANCE SERVICE AND TROUBLE SHOOTING
6-1. Trouble alarm and solve method
phenomena
Exlpalanation
●The spinning is intermittent when it starts.
●Balance the laundries to avoid slanting
●The wash procedure is paused.
●The cloth sensor is checking the cloth,it will add water afte
r 48
seconds.
●Push the PROGRAM button to select SPIN,but it
doesn't work.
●The program is setting the drain time. Some time is needed bef
ore it
starts spinning.
●The pulsator pauses during water inlet in wash and
rinse.
●It is to avoid splashing during water inlet.
●There may be some water fl
owing out of the drain
hose in the first use of the machine.
●It is the water remained in the factory inspection of performa
nce.
Note: when the digital tube displays the abnormal symbol during working,it buzzs once in succession every two minutes
if
FA
Push
Is the drain hose set too low?
The height of the end of the drain hose
should be between 900mm-1200mm
The display shows F2.
Is the water level too high?
Check the water valve whether can be close
Drain away water,then run again
The display shows EL.
Is the laundry too much
？
Put part of the laundry out,then
push the Start/Pause button.
Is the pump filter blocked?
Open the pump filter and remove dirts
Open the front control board,check the connection of the
wire and the sequencer
Change the water level sensor
Change the sequencer
LMA4120WPAB0
、
LMA4120WBAB0
LCA4120WPAB0