Spin process
1
Put the laundries in properly
2
Put the gland in properly
3
Close the inner and outer cover of the spin tub
4
Do you need water-added
Rinsing-spinnning
Water-added rinsing-spinning
has an effect that can remove the surplus liquid dirt,
Spin for about
1~2 minutes
Foam-removing
spinning
Remove most of
the foam extra
detergent liquid.
Remove the detergent
liquid remained
The effect is best when the laundries quantity is below 80% of the rated value.
Spin
Fill water for
about 1 minutes
Spin for about
1~2 minutes
Note:
Refer to the Notes on Spinning carefully.
5 Take the laundry out when the spinning ends.
When the spinning ends, open the top lid and the interior lid. Then take out
the depression cover and laundry after the spinning drum has stopped
rotation completely.
Note: If there needs no
water-added rinsing-spinning
, set the duration for
spinning directly.
Water inlet entrance
Water inlet hose
Install the water inlet hose
The water hose should be connected
as shown in the right figure.
It works in a way as follows:
If you need
water-added rinsing-spinning
, please check the connection
between the water hose and filling inlet.
Notes on Spinning
Use the foam-removing spin-
ning to remove the extra deter-
gent liquid. It can both shorten
the washing time and save the
water consumption.
Please put in the gland properly even if the laundries
.
Do not leave any articles above the depression cover.
Push
Gland
Push
Proper
The laundries
are slanting
Proper
No gland
quantity is small.
