Haier HWS60-12F2S, User Manual

Page: 29 / 82

29 29
• Your machine may have either a single inlet
(cold) or double water inlets (cold/hot) based on its
specifications.
White-capped hose should be connected to cold
water inlet and red-capped hose to hot water inlet
(applicable for machines with double water inlets).
• To eliminate water leakages in points of contact,
1 or 2 nuts are provided in the hose package (ap -
plicable for machines with double water inlets).
Fit these nuts to the ends of new water inlet hoses
on the side of faucet.
• Mount new water inlet hoses to a ¾ ˝, threaded
tap.
• Connect the white-elbow end of the water inlet
hoses to the white-filtered water inlet valve on the
rear side of the machine and the red-elbow end to
red-filtered one (applicable for machines with dou -
ble water inlets).
Tighten plastic parts of the junctions using your
hand.
In uncertain conditions, have the connection works
be done by a qualified plumber.
• Flow of water with pressure of 0,1-1 Mpa will al -
low your machine to operate more efficiently.) (0,1
Mpa pressure means that more than 8 litres of
water will flow through a tap that is turned fully on
per one minute.)
• Ensure that the pipes and all water connections
do not leak by tapping the tap moving the hoses
slightly after making the connections.
CHAPTER -3: INSTALLATION OF THE MACHINE
(WATER INLET HOSE CONNECTION)
3/4”
10
mm