15
Common phenomena
Phenomena
Explanation
The wash procedure is paused
The digitron displays E0.
The safety switch acts, and the spin-
ning cannot work. Amend twice
automatically ,The digitron displays E3.
The water filling does not work, or is
slow. The digital displays E4.
The drainage cannot work, or is too slow.
The digitron displays E1.
It stops running in midway. The digitron
displays E2.
The top lid is not closed.
The top lid is opened during reserve
procedure.
Close the top lid.
Close the top lid.
Is the drain hose put down?
Is the drain hose blocked?
Put down the drain hose. Open and close the
top lid once.
Clean the foreign material. Open and close
the top lid once.
Are the laundries put slantingly?
Is the machine slanting?
Reorder the laundries. Close the top lid.
Placed the machine horizontally, open
and close the top lid once.
Is the water tap opened, or is there water
supply failure?
Is the water inlet valve blocked?
Is the water pressure too low?
Open the water tap. Open and close the
top lid once.
Clean the water inlet valve then open and
close the top lid once.
Use after the water pressure is normal.
The water level sensor is bad.
Please contact the after-sales
service department.
Is the machine slanting?
Are the laundries put slantingly in spinning?
Are there any foreign materials?
Is the screw of the jointer of water
inlet hose loose or awry?
Adjust the machine to be even
Reorder the laundries and close the top lid.
Remove the foreign materials.
Fasten the screw of the jointer properly.
The water tap leaks
The digitron displays E6.
There's abnormal sound
inside the machine
Phenomenan The reason How to settle
Trouble-shooting Answer to question
(If there's breakdown, please pull off the power plug before checking) The following phenomena are not breakdowns
sometimes. Please confirm again before sending it to repair. If there are real breakdowns, please come to the special
maintenance department or after-sale service department of our company. Do not repair it by yourself.
The machine does
not act
Not wash
Not spin
Is there power failure?
Is the power plug inserted tightly?
Is the water level reached preset position?
Please use it when there's power supply.
Insert the power plug tightly.
Fill water to the preset position.
Is the power plug inserted tightly?
Is the top lid closed reliably?
Are the laundries set flat?
Insert the power plug tightly.
Close the top lid.
Set the laundries flat.
It is the water remained in the factory inspection
of performance.
Balance the laundries to avoid slanting.
The program is setting the drain time. Some time is
needed before it starts spinning.
The spinning is intermittent when it starts.
There may be some water flowing out of
the drain hose in the first use of the machine.
Push the "spin" button to select "Spin",
but it doesn't work.
The cloth sensor is checking the cloth, it will add
water after 48 seconds.
The pulsator pauses during water inlet in wash
and rinse.
It is to avoid splashing during water inlet.
It is the special resume function.
In the case of power failure
or the power plug is loose during washing, the machine can
save the running program, and resume the program after
the power supply is recovered. You do not need to set the
program again.
When the power plug is inserted, computer
board indicator is switched on, and the machine
starts working
