Installing Your W asher:
Read though theseInstructions Carefullybeforeinstallation.
1. Insert a new flat washer into eachendof the water inlet hoses.
Fir mly put the washers in the coupling.
Note:
You may haveto use pliers to tightenthe coupling. Do not over tighten
becauseyou may causedamageto the valve.
2. Connectthe hot and coldwater inlet hosesto the hot and
coldwater Faucet.
3. Connect the other end to the corresponding washer inlet located at the back of
machine.
You should use the new hose-sets supplied with the washer. Old hose-sets
should not be reused.
4.install the drain hose to the side of the washer using the drain hose damp provided.
The drain hose must be placed into a drainpipe or sink at least 1 1/2inches in diameter.
Use the gooseneck to the hose in place. To avoid possible water back up, the drain
hose must reach a minimum height of 900mm and a maximum height of 1200mm.
5.Pug in the washer to a regular 230-240Volt/50Hz,10Amps outlet.
Note :Carefully inspect all around the machine and at the back for
any leaks, and tighten any loose connections.
Caution:
If, after completingthesesteps,you are unsure that unit is properly
installed, contacta qualified installer. To ensure that your W asher is
properly installed it is recommended
that it be installed by a certified
installer.
Water Inlet
Water Supply Hose
Goose Neck
Hose Bend
Drain Hose
18