Haier HWM100-FD10829, User Manual

Page: 17 / 32

5-Daily use
1. A
The appliance switches off automatically.
t programme cycle end is displayed.
2.
3. R
Turn off the water supply.
emove laundry as soon as possible to go easy on it and to prevent more wrinkling.
4.
5. Unplug the power cord.
6 . Open the door to prevent formation of moisture and odours. Let it open while not used
minutes before starting the program or at the end of program.The display swit-
ches off.
.
To interrupt a running programme press gently “Start/Pause”. The LED in the button is
flashing. Press it again to resume operation.
To cancel a running programme and all its individual settings:
1. Press
Press “Power” button for about 2 seconds to switch the appliance off.
Press “Power” button to turn on the appliance, select programme “Spin” and then
select “no Speed” (speed lights are off). start the machine to drain the water.
“Start/Pause” button to interrupt the running programme.
2.
3.
4. After closing the program to restart the appliance, select a new programme and
5.12 After washing
Note: Door lock
For safety reasons the door is locked partially during the washing cycle. It is only pos-
sible to open the door at the end of the programme or after the programme was can-
celled correctly (see description above).
In case of high water level, high water temperature and during spinning it is not pos-
sible to open the door; is displayed.
Note: Standby mode / energy-saving mode
The switched on appliance will go into standby-mode if it will not be activated within 2
This saves energy. To interrupt the standby mode push “Start/Pause” button.
5.10 Start wash programme
Press “Start/Pause” button (Fig.5-8) to start. Applia-
nce operates according to present settings. Changes
are only possible by cancelling the programme.
5.11 Interrupt- cancel wash programme
5-8
5.13 Act
minutes before starting the program or at the end of program. The display switches
ivate or deactivate the buzzer
The acoustic signal can be deselected if necessary:
1. Switch on the appliance.
2. Select the SPIN programme.
3.
Press the “Extra rinse” button “Temp.” button and “Spin” button at the same time
for about 3 seconds. “ ” will be displayed and the buzzer will be deactivated.
For activating the buzzer press these two buttons at the same time again. “ ”
will be displayed.
Start/Pause
off.
16
start it.