Haier HWM 80-200 S, Operating Manual, Page: 5 / 13

5
Usage of the drain hose
4. If extra drain hose is needed, please
make separate purchase. The inner
diameter of the extra hose shall not less
than 30mm, and the length shall not
exceed 1.5m.
-4
If extra drain hose is too long, cut it either
at point A or B. 5.
-5
The drainage shall be smooth with
the drain hose.
1. The height of the drain hose shall be less
than 10cm, or the drainage will not be
smooth enough and cause incomplete
drainage.
2. Do not tramp on or press the drain house.
-1
-2
3.
If the drain hose is too long, cut it at mid
point. To make smooth drainage, cut the
front end of the hose slantingly.
-3
Before Using
Installation and adjustment
6
Before Using
Installation and adjustment
How to Change the direction
of the drain hose
Figure 1 indicates the ex-factory installation
position of the drain hose.
Put soft items on the ground. Lean the machine
down gently with the front surface facing the
ground. Take off the drain hose from the cabinet.
Take the hose out of the fixing groove. (See to
Figure 2).
Embed the drain hose into the groove along the
side of the spin tub in the order of (1)~(3),
heading for the side of the spin tub. (See to
Figure 3).
Extend the drain hose from the side of spin tub
1.
-1
2.
-2
-3
3.
Embed the drain hose into the groove with
hands. Take care not to damage the drain hose
in fastening the fixing clamp.
4.
4.
J
-
¦ O
$
Å
3
Ð
1
Æ _
. 3 e g + i
Ã
^

§ s
M
m
~
Î D Y N X