6
In
on
Dismantle the transport on bolts
The transpo
on bolts are designed for clamping an -
vib
on components inside of the washing machine during
the transpo
on process.
Remove the back cover.
Remove the four bolts on the rear side and take out
Replace the back cover.
Fill the holes le by the bolts with blanking plugs.
Note:
When you replace the back cover, the convex
must face to outside, and you have to insert the
back cover from the two gaps as sho
wn in fig.5.
Keep the transporta on bo
stabilizers in a safe place for later use.
Adjus ng the feet
There are adjustable feet under the bo om of the washing machine. Before
use, they should be adjusted so that the machine is level. This will minimize
vibr ons and thus noise during use. It will also reduce wear and tear. We
recommend using a spirit level to level the appliance.
The fl
oor should be as
stable and fla
t as possible.
Before Use
5.
2.Put down the machine backwards, Remove the four screws (figure 2.)
upright.
1.
3.
2.
Warning.The washing machine is very heavy.Use safe lifting techniques
plastic board
plastic board and a felt.
They are used for
plastic board(figuer 1.)
plastic board which the side with felts is inward.then install the screws which go
plastic
7
Inlet Hose
Connect the nut on the inlet hose to the
connector on the water valve.
Connect inlet hose to a water tap with cold,
fresh water.
Use the hose-set supplied with the appliance.
Old hose-sets should not be reused.
Drain Hose
Use the drain hose bracket to keep the end of the
drain hose retained and prevents the
of
water. Don't extend the length of the drain hose; if
an extended hose is required, please consult a
serviceman or plumber.
The height of the drainage outlet must be 80-100
cm. Fix the drain hose to the clip at the back of the
washing machine to prevent it from dropping o
ff
.
The drain hose should not be submerged in water and should be securely
fi
xed and leak-free.
If the drain hose is placed on the ground or if the pipe is at a height of less than 80cm, the
washing machine will con nuously drain while being
fi
lled (self-siphoning).
Conne ng to Power Supply
Before connec ng to the power supply, check:
The socket is adequate for the maximum power of the washing
machine (For safety, fuses in the power circuit should be rated
for no less than 10A).
The voltage should meet the requirement
The power outlet should be capable of accep ng the washing
machine plug.
Connect the machine to an earthed socket outlet.