Haier HW90-BP14959, User Manual, Page: 24 / 60

8-Troubleshooting
Should the error messages reappear even after the taken measures, switch off the
appliance, disconnect the power supply and contact the customer service.
8.4 In case of power failure
The current programme and its setting will be saved.
When power supply is restored operation will be re
-
sumed.
In case of power failure during programme run door
opening is mechanically blocked. If the laundry is to
be removed, the water level must not be visible in the
glass door. -Danger of scalding!
Lower the water level according to step 1 to 6 of
chapter CARE AND CLEANING (PUMP FILTER).
door
Pull lever (A) beneath service flap (Fig.8-4) until
i
Fix all parts and close the service flap.
s unlocked by a gentle click.
8-4
Note: Foam formation
If too much foam is inspected during spin cycle, motor stops and drain pump will be ac
-
tivated for 90 seconds. If that elimination of foam fails up to 3 times, programme ends
without spinning.
Washing programme duration will
be adjusted.
This is normal and doesn’t af-
fect functionality.
Spinning fails. Check machine load and laun-
dry and run a spinning progra-
mme again.
.
Degree of pollution does not agree
with selected programme.
Select an other programme.
Choose the detergent accord-
ing to the degree of pollution
and according to manufacturer
specifications.
Maximum load has been exceeded.
Reduce loading.
Laundry was unevenly distributed
in the drum.
Loose the laundry.
Washing powder
residues are on the
laundry.
Insoluble particles of detergent can
remain as white spots on the laun
-
dry
Unsatisfactory wash-
ing result.
.
Detergent quantity was not sufficient.
Perform extra rinse.
Try to brush the points from the
dry laundry
Unbalance of laundry.
.
Choose an other detergent.
Laundry has grey
patches.
Caused by fats such as oils, creams
or ointments.
Pretreat the laundry with a spe
-
cial cleaner.
Automatic adjustment
of washing time.
Problem Cause Solusion
23