21
MAINTENANCE
DISPLAY CODES
DISPLAY CODES AND SPECIAL FUNCTIONS
¬ Control panel lock function: Press the "Delay" and the "Start/Pause" buttons simultaneously for 3 seconds after starting a program.
It can no longer be changed by operating buttons or knobs. To unlock press the "Delay" and "Start/Pause" buttons again for 3
seconds.
¬ Power-off memory function: In case of abrupt power failure or the need to cut off the power during a program cycle, the present
settings will be saved and the preset operation will resume when the power is on again.
¬ To cancel a program
Press the "Start/Pause" button, then switch off the power and the program is automatically cancelled. Turn the program selector
again to choose another program.
Note: During the spin process, if too much foam is inspected, in order to protect the motor, the washing machine will eliminate the
foam automatically; the motor will stop and the drain pump will drain the water continuously for 90 seconds. If it happens more than
3 times, the motor will stop until the end of cycle without spinning.
CODES
CAUSES
SOLUTIONS
Err1
¬ Door is not properly shut.
_ Shut the door properly and then press the Start/Pause button.
Err2
¬ Drainage error, water not emptied within 6
minutes.
_ Clean the filter and check the drain hose for blockage. If error
still exists, please contact the maintenance personnel.
Err3
¬ Temperature sensor not properly connected or
damaged.
_ Contact the maintenance personnel.
Err4
¬ Heater error (Appears at the end of a cycle).
_ Contact the maintenance personnel.
Err5
¬Water level not met in 8 minutes.
¬The height of the drain hose is below 80 cm.
¬ The drain hose is in water.
.l
a
m
r
o
n
si
e
r
u
s
s
e
r
p
r
e
t
a
w
d
n
a
,
n
o
d
e
n
r
u
t
si
p
a
t
t
a
h
t
e
r
u
s
e
k
a
M
_
If problem still exists, please contact the maintenance personnel.
_ Install drain hose within 80-100 cm of height.
_ Make sure the drain hose is not in water.
Err7
¬ Motor error
_
.
Contact the maintenance personnel.
Err8
¬ Water exceeds protective level.
_ Contact the maintenance personnel.
End
¬ End of wash cycle.
1:25
¬The remaining time is 1 hour 25 minutes.
19:30
¬Status information:Preset time for delayed operation.
UNb
After the last rinsing cycle finishes,spinning fails completely due to unbalance of the laundry.
EuAr
¬ The PBC and the motor cant’t communicate.
_ Contact the maintenance personnel.
Er10
_ Contact the maintenance personnel.
¬ The signal of Water level sensor is wrong.