Haier HW50-10F1, User Manual, Page: 29 / 81

29 29
• Your machine may have either a single inlet
(cold) or double water inlets (cold/hot) based on its
specifications.
White-capped hose should be connected to cold
water inlet and red-capped hose to hot water inlet
(applicable for machines with double water inlets).
• To eliminate water leakages in points of contact,
1 or 2 nuts are provided in the hose package
(applicable for machines with double water inlets).
Fit these nuts to the ends of new water inlet hoses
on the side of tab.
• Mount new water inlet hoses to a ¾ ˝, threaded
tab.
• Connect the white-elbow end of the water inlet
hoses to the white-filtered water inlet valve on the
rear side of the machine and the red-elbow end
to red-filtered one (applicable for machines with
double water inlets).
Tighten plastic parts of the junctions using your
hand.
In uncertain conditions, have the connection works
be done by a qualified plumber.
• Flow of water with pressure of 0,1-1 Mpa will
allow your machine to operate more efficiently.)
(0,1 Mpa pressure means that more than 8 litres
of water will flow through a fully open tap per one
minute.)
• Ensure that points of contact do not leak by
tapping the tap completely after carrying making
the connections.
CHAPTER -3: INSTALLATION OF THE MACHINE
(WATER INLET HOSE CONNECTION)
3/4”
10
mm