Haier HW100-B12636N, User Manual

Page: 25 / 100

GB
10-Installation
25
10.1 Preparation
▶
Take the appliance out of the packaging.
▶
Remove all packaging material including polystyrene base, keep them out of childrens
reach. While opening the package, water drops may be seen on plastic bag and port-
hole. This normal phenomenon results from water tests in the factory.
10.3 Dismantle the transportation bolts
The transportation bolts are designed for clamping
anti-vibration components inside the appliance during
transportation to prevent inner damage.
1. Remove the back cover (Fig. 10-2).
2. Remove all 4 bolts on the rear side and take out
plastic spacers (A) from inner side of the machine
(Fig. 10-3).
3. Replace back cover by inserting it in the two gaps
its convexity is facing out (Fig. 10-4).
4. Fill left holes with blanking plugs (Fig. 10-5).
10-3
3
A
10-2
10-4 10-5
Note: Packaging disposal
Keep all packaging materials out of children´s reach and dispose them in an environmen-
tally friendly manner.
10.2
(1) (2)
(3)
10-1
2x
2x
Noise Resuction Pads Installation Instructions
noise reduction pads.
These are used for reducing noise. (Fig. 10-1)
3.
2. Lay the washing machine down to its side, porthole
pointing upwards, bottom side towards operator.
pads and remove the
double-sided adhesive prot ective film; the noise redu-
ction pads under the washing machine cabinet as
shown in Figure 10.1(3) two longer pads in position 1
and 3, two shorter pads in position 2 and 4). Finally set
the machine upright again.
1.
Warm tip:
Noise reduction pad is optional , could help to reduce
noise , please assemble it or not according to your
own demand.