Haier HW100-1211N-F, User Manual

Page: 7 / 44

6
In on
Dismantle the transport on bolts
The transpo on bolts are designed for clamping an -
vib on components inside of the washing machine during
the transpo on process.
Remove the back cover.
Remove the four bolts on the rear side and take out
the syn
c stabilizers from within the machine.
Replace the back cover.
Fill the holes le by the bolts with blanking plugs.
Note:
When you replace the back cover, the convexity
must face to outside, and you have to insert the
back cover from the two gaps as sho
wn in fig.5.
Keep the transporta on bolts and synthe c
stabilizers in a safe place for later use.
Adjus ng the feet
There are adjustable feet under the bo om of the washing machine. Before
use, they should be adjusted so that the machine is level. This will minimize
vibr ons and thus noise during use. It will also reduce wear and tear. We
recommend using a spirit level to level the appliance.
The fl
oor should be as
stable and fla
t as possible.
Before Use
5.
1.)
2.Put down the machine backwards, Remove the four screws (figure 2.)
board (figure 3).Finally keep the machine
upright.
1.
3.
2.
(HW100-1411N-F,HW100-1211N-F,
HW70-1411N-F,HW70-1211N-F)