Installation
EN
Water Supply Connection
▶
▶
Pressure of the cold water supplied to the automatic
icemaker is between 0.15-0.6 Mpa.
▶
The water tube should be of an appropriate length,
usually 8 metres, and should be free of bends after
being inserted into place. If the water pipe is too
long then the water pressure will be reduced, af-
fecting the ice and cold water content.
▶
DO NOT connect to the water supply when the
ambient temperature is below 0°C, otherwise the
water pipe may freeze.
▶
Always connect to the drinking water supply.
▶
Keep the water pipe away from heat sources.
▶
The water fi lter is there to fi lter impurities in the
water, and to make ice clean and hygienic. It cannot
sterilise or destroy anything , so be certain to con-
nect the water pipe to a drinkable water source.
▶
Automatic water system, do not manually add water.
▶
If the ice maker is turned on but the appliance is not
connected to water,the ice maker will not work.
WARNING!
It is recommended to have this product installed by
a qualifi ed technician.
Fitting the Water Filter
Measure out and cut the length of pipe required from
the fi lter to the Fridge-freezer and from the fi lter to the
water supply. Make sure that you achieve a square cut
using a sharp knife. Push fi t one of the pipes into the
water fi lter (Fig.1). Secure the pipe to the fi lter by sliding
a locking clip into the groove a shown (Fig. 2).Repeat
the procedure on the other end of the fi lter. Connect
the end into the plastic adaptor (Fig.3). Screw the
adaptor onto a suitable ½” BSP connector water outlet.
Access the water valve assembly at the back of the ref-
rigerator. Push the pipe into the valve assembly (Fig.4).
Comissioning the Water Dispenser
Before fi rst use, press the water dispenser pad several
times for 1 minute. Do not press for more than 1
minute to prevent overheating of the pad activator
solenoid. Cold water will begin to fl ow from the outlet.
Notice
For further installation details refer to the instruc-
tions supplied with the water fi lter.
34
ArtNo.601- 0010 - S xS 661- 9 - P ipe to filter
1.
ArtNo.601- 0005 - S xS 661- 9 - Se curing the pipe
2.
ArtNo.601-0014 - P ipe to BSP connector
3.
4.
