![background image](http://html.mh-extra.com/html/haier/ht-3768/ht-3768_service-manual_138130007.webp)
Electrostatic ally Sensitive (ES) Devices
Some semiconductor (solid state) devices can be damaged easily by static electricity.
Such components are usually called Electrostatic ally Sensitive (ES) Devices.
Examples of typical ES devices are integrated circuits and some field effect
transistors and semiconductor “chip” components. The following techniques should
be used to help reduce the incidence of component damage caused by static
electricity.
1. Immediately before handling any semiconductor component or semiconductor-
equipped assembly, drain off any electrostatic charge on your body by touching a
known earth ground. Alternatively, obtain and wear a commercially available
discharging wrist strap device, which should be removed to prevent potential
shock prior to applying power to the unit under test.
2. After removing an electrical assembly equipped with ES devices, place the
assembly on a conductive surface such as aluminum foil, to prevent electrostatic
charge buildup or exposure of the assembly.
3. Use only a grounded-tip soldering iron to solder or unsolder ES devices.
4. Use only an anti-static type folder removal device. Some solder removal devices
not classified as “anti-static” can generate electrical charges sufficient to damage
ES devices.
5. Do not use freon-propelled chemicals. These can generate electrical charges
sufficient to damage ES devices.
6. Do not remove a replacement ES device from its protective package until
immediately before you are ready to install it. (Most replacement ES devices are
packaged with leads electrically shorted together by conductive foam, aluminum
foil or comparable conductive material).
7.
Immediately before removing the protective material from the leads of a
replacement ES device, touch the protective material to the chassis or circuit
assembly into which the device will be installed.
CAUTION:
Be sure no power is applied to the chassis or circuit, and observe all
other safety precautions.
8. Minimize bodily motions when handling unpackaged replacement ES devices.
(Otherwise even some normally harmless motions such as mutual brushing of
your clothes’ fabric or lifting of your foot from a carpeted floor might generate static
electricity sufficient to damage an ES device.)
General Soldering Guidelines
1. Use a grounded-tip, low-wattage soldering iron and appropriate tip size and
shape that will maintain tip temperature within the range of 500
o
F to 600
o
F.
2. Use an appropriate gauge of RMA resin-core solder composed of 60 parts tin/40
parts lead.
7
Summary of Contents for HT-3768
Page 36: ......
Page 37: ...B Circuit Diagrams 1 ...
Page 38: ...Sincere Forever Haier Group Tel 86 532 8938356 Web site http www haier com ...