section
Preparation Before Use
Remove all packing materials,
including foam, base pads,
and tape used to attach
accessories.
C h e c k
a c c e s s o r i e s
a n d
documents:
Check materials against the
packing list. If any are different
or missing, inquire with the
retailer.
Every time the temperature settings
are changed, it takes some time for the
temperature to adjust.
The length of
time depends on the amount of change,
the ambient temperature, frequent
door openings, quantity of stored food,
etc.
Copy the fridge model number and manufacturer's serial number for all service calls
or inquiries you may have in the future.
It is recommended to clean the fridge
before use. Mix 4 liters of water with 1
tsp baking soda. Wipe the interior and
exterior with a soft cloth moistened with
this mixture
On Standby:
After the fridge is put into place, adjusted, and
cleaned, connect the power to begin normal
operation.
Connecting the Power:
The default temperatures for all
three compartments are set at the
m i d d l e
r a n g e
f o r
f r e e z e r ,
refrigerator and convertible drawer
as a refrigerator.
Fridge work mode:
Manual adjustment: Set the temperature by
pushing the temperature-adjusting button.
(Refer to "Function"section.)
Convertible
drawer will be set in the refrigerator mode by the
factory.
Put food inside the fridge:
After the fridge has been plugged in
and is fully cooled, it is safe to put in
food and begin use.
Handles Install and Removal:
Note: Remove protective plastic covering from all handles.
1. Refrigerator and Freezer Door Handles Installation
a.) handles are packed inside the fresh food compartment.
b.) carefully remove the handles from the packing material.
c.) Position the long handle marked REF TOP to the right door of the refrigerator.
d.) Align the handle onto the handle bolts.
e.) Pull the handle downward until handle locks in place.
f.) Repeat steps above for long freezer door handle (FRZ TOP).
2. Convertible Drawer Handle Installation
a.) Position the short handle onto the Convertible Drawer Bolts (slight horizontal bend upward).
b.) Pull the handle to the left until handle locks in place.
3. Removing Handles Follow Opposite Process
4. Door Bin Installation
a.) Remove 4 door bins from inside the fresh food and freezer compartments.
b.) Carefully remove all protective wrappers.
c.) Position the narrow bins (2L) onto the lower door liner tabs of the fresh food door to clear crispers properly.
d.) Position bins down over tabs to lock in place.
e.) Position the remaining bins as shown (see picture).
