Check the following items before connecting to the power supply.
The socket conforms to the maximun power load (The maximum current load of
the socket and power supply cable should not be less than 15A).
Power supply voltage conforms to the required value.
The power supply socket and the plug of the washing machine compatible; if they
are compatible Refer to a washing machine technician or a Haier designated service
point for power cable replacement. The washing machine should be connected to an
earth before use.
Supplementary earth cable should not be necessary if the socket is connected to
the earth.
Supplementary earth cable should be installed on the upper back of the washing
machine andconnected to an earth if the power supply socket has no earth connection.
Caution: The supplementary earth cable should not be connected to water or heating
pipes
5
Installation
Connection of water inlet hose and washing machine
1. Place the water inlet hose nut on the
connector of the water inlet valve.
2. slightly shake the water inlet hose nut to see
if it is tightly and properly fixed.
water inlet hose nut
connector of water inlet valve
Water drainage hose
Connection of power supply
The height of the terminal of the water drainage hose should be
between 80cm-100cm, The water drainage hose must be securely
placed on the clip on the back of the washing machine.
Use the water drainage support supplied as an accessory for proper
installation of the water drainage hose. fix the water drainage hose
support with waterproof sring . Do not use an excessively long water
drainage hose and contract the authorized technician if the water drain-
age hose needs to be extended. the water drainage hose should not
be extended more than250cm. ( longer extension will result in concur-
rent water inflow and outflow).The diameter of the extension hose should
be the same as the original hose.
caution: water drainage hose must not be immersed in water. the origi-
nal and extension hoses should be tightly connected.
100cm
80cm
12
Maintenance
1. Turn of the water and electricity sup-
ply after every wash. Open the door to
prevent the formation of moisture and
odors. If the washing machine is left idle
for a long period, drain any remaining
water in the machine and replace the
drainage hose.
2. Unplug the machine during cleaning and
maintenance. Use a soft cloth dampened with
soapy liquid to clean the machine case and
rubber components. Do not use corrosive or
abrasive chemicals or solvents.
3.Clean the detergent compartment
regularly. For the detergent compartment
similar to figure (a), raise the compart-
ment slightly to remove and replace af-
ter cleaning.
4. Cleaning the Filter (once a month).
Press the lower edge of the filter compartment
cover to open; (Fig 1-2)
Remove the filter by turning counterclockwise;
(Fig3);
Flash clean with running water;
Filter replacement is the reverse of removal.
Caution: Attention shall be paid to ensure that
the filter is replaced correctly to avoid possible
leakage.
fig. 1
fig. 2
fig. 3
5. To prevent blockages
to the water supply or
the ingress of contami-
nants, clean the water
inlet and inlet water fil-
ter regularly.
7. If the washing machine is
left idle for a
long
period
turn
off
the
water
and
electricity supply
and open
the door slightly to prevent
the formation of moisture and
odours.
6. If the machine is to be moved a distance, location,
replace the vibration mounting locks which were
removed during installation as shown below.
Remove the back
cover.
Replace the rubber
plugs.
Insert the bolts
Tighten the bolts with the
spanner provided.
Replace the rear
panel.
)LJD