8
INSTALLATION INSTRUCTIONS
Installation
WARNING!
This product is heavy and requires two persons for installation.
WARNING!
Failure to install the screws or fixing device in accordance with these instructions may
result in electrical hazards.
The manufacturer is not liable for any damage caused by not following these instructions.
1
Prepare the rangehood for installation
●
Before commencement, unpack the rangehood and check that it functions correctly.
●
The room in which the rangehood is used should be well ventilated and contain no
flammable, explosive or corrosive materials or articles.
●
The wall used for mounting the rangehood should have sufficient strength and a flat surface.
●
When drilling holes in the wall, do so away from water, electricity or gas lines to
prevent hazards such as electric shocks or gas leaks.
●
Temporarily mark the height of the bottom of the rangehood and the centre of the
cooktop on the wall according to the information given on page 8.
2
Install the wall plate
●
●
Fit the expansion plugs into the holes.
●
Secure the wall plate to the wall using the mounting screws.
3
Install the decorative cover holder (if inner decorative cover extension is to be used)
●
●
Fit the expansion plugs into the holes.
●
Secure the decorative cover holder to the wall using the mounting screws.
73 mm
280 mm
50 mm
224 mm
50 mm
4
2 mm
5
6
5 mm
Decorative cover holes
Stopper screw hole
Wall plate holes
Fig.1
Use an impact drill with a φ10 mm masonry bit to drill 55mm deep holes in the wall in the locationgs
of the wall plate holes and stopper screw holes as shown in Fig.1and 2.
Use an impact drill with a φ10 mm masonry bit to drill 55mm deep holes in the wall in the locationgs
of the decorative cover holes as shown in Fig.1and 2.
