Haier HDW15F3S1, User Manual

Page: 33 / 40

Troubleshooting
滚滚长江东逝水
Problem Possible cause Possible solution
Acoustic alarm,
display shows
ALARMCODE
Leak: The drain
pump
runs permanently!
•
•
•
•
•
•
Close the water tap.
Disconnect appliance from
power supply.
Contact Service.
Anti-flood device is on:
There are water leakages
in the appliance.
The water inlet valve is
open and blocked.
The drainage is blocked.
The dishes are not
clean.
Filters are clogged.
Filters are not correctly assem-
bled and installed. correctly assembled and installed.
Spray arms are clogged.
Rem
Clean the filters.
Make sure that the filters are
ove remaining food remnants
with a thin pointed object.
Programme was not applicable
for the type of load and food
remnants.
Make sure that the programme is
applicable for the type of load and
food remnants.
Incorrect position of the items
in the baskets. Water could not
wash all items.
Make sure that the position of the
items in the baskets is correct and
that the water can easily wash all
items.
Spray arms could not turn freely.
Make sure that the position of the
items in the baskets is correct and
does not cause the blockage of the
spray arms.
quantity of detergent in the deter-
gent dispenser.
Make sure that you add the correct
quantity detergent in the dispenser
before you start a programme.
The wash cycle was interrupted
by a long break.
Do not open the door or cut power
supply during the wash cycle.
Whitish streaks,
stains or bluish layers
on glasses and dishes.
Released quantity of rinse aid is
too much.
Decrease the released quantity of
rinse aid. Refer to section
DIFFERENT SETTINGS FOR RINSE
AID.
Quantity of detergent was too
much.
Make sure that you add the correct
quantity of detergent in the dispenser
before you start a programme.
Multitab detergent tablets used
with a short programme might
not fully dissolve.
Select a longer programme when
using Multitab detergent tablets .
No detergent or insufficient
Washing Results are not satisfactory
32
Troubleshooting
NZ AU