23
All other Alarmcodes:
1.
Note Alarmcode
2.
Contact Service ; refer to CUSTOMER SERVICE
Troubleshooting
Problem
Possible cause
Possible solution
Acoustic alarm,
display shows
ALARMCODE
The appliance does
Water tap is closed.
•
Open the water tap.
Note:
Whenever Error ‘ ’ is
solved switch off the appliance
and restart the programm.
Water inlet hose has a kink or
a bend.
Make sure that the position of
the hose is correct.
In case of aqua-stop system:
water protection is triggered;
the marker (C) is red.
The hose must be replaced.
Filter in the water inlet hose
is clogged.
.
Water inlet is clogged.
Check water flow from tap.
Water pressure is too low.
Contact your local water
authority.
Acoustic alarm,
display shows
ALARMCODE
The appliance does
Filters are clogged.
•
Scoop out as much water as
possible.
•
•
Continue programme by
pressing the START/PAUSE
button.
The drainage is blocked.
•
Scoop out as much water as
possible.
•
Make sure that drain water-
connection and piping is
correct and not blocked.
•
Continue programme by
pressing the START/PAUSE
button.
Acoustic alarm,
display shows
ALARMCODE
Leak: The drain
pump
runs permanently!
•
There are water leakages in
the appliance.
•
The water inlet valve is
open and blocked.
•
The drainage is blocked.
1
Close the water tap.
2
Disconnect appliance from
power supply.
3
Contact Service.
Error codes on the display
Clean the filter at the inlet hose
connections at tap and the rear
of the appliance.
If the fault persists, contact
customer care.
•
Anti-flood device is on:
.