EN
After 3 seconds the delayed start indicator “ E ” blinks, the time-remaining indicator “ G ” will blink and
decrease , the programme will start until the delayed start indicator “ G ” goes out .
Reset drain function
You can use Reset drain function to stop the washing cycle under running by Rotating the knob to
"Reset ", and the appliance will stop after a few minutes drain phase.
Cancelling or modifying a cycle
A cycle that is underway can be modified if it has only been running for a short time. Otherwise, the
detergent may have already been used, and the appliance may have already drained the wash water.
If this is the case, the detergent dispenser must be refilled ( see the paragraph entitled, “ Loading the
detergent ”).
To modify a cycle that is already underway, follow the instructions contained in the paragraph entitled
"Reset drain function", and select the programme you wish (see the paragraph entitled, "Switching
the dishwasher ON").
20
This button (see" Close-up View (Control Panel), letter " D ") makes it possible to wash dishes using only
the upper rack if there are not enough dishes for a full load. This will allow you to save on water and
energy consumption.
Press the HALF LOAD load button “ D
Select the programme ( see the paragraph entitled“ Switching the dishwaher ON”)
If the door is closed, after 3 seconds, the programme starts automatically.
- Please keep in mind that the amount of detergent should also be adapted to the HALF LOAD.
D ” again ,
“ C”
goes
out.
B
A
D F
C
G
E
I
H
"HALF LOAD" Button
J
To select "HALF LOAD":
” , HALF LOAD load indicator “ C ” lights.
- To cancel the HALF LOAD , you can press the HALF LOAD button “
HALF LOAD indicators
until the
