7
2
1
4
3
6
5
When the low rinse aid indicator lights, you must load rinse aid.
Rinse aid
This product makes dishes sparkle and helps them to dry without spotting. The dispenser is located on
the inside panel of the door .
Loading the rinse aid
Regardless of the type of detergent dispenser installed on your appliance,
you must proceed as indicated below when loading the rinse aid.
To open the dispenser, turn the "1" cap in an anti-clockwise direction
and then pour in the rinse aid, making sure not to overfill. The amount
of rinse aid used for each cycle can be regulated by turning the "2"
dose adjustor, located beneath the "1" cap, with a screwdriver. There
are 6 different settings; the normal dosage setting is
1.
Important
Proper dosage of the rinse aid improves drying.
If drops of water remain on the dishes or spotting occurs, the dosage adjustor should be
turned to a higher setting.
If the dishes have white streaks, turn the dosage adjustor to a lower setting.
H
ow to fill the rinse aid and the detergent dispenser
Detergent
D
etergent specifically intended for use with dishwashers must be used.
The dispenser must be refilled before the start of each wash cycle
following the instructions provided in the "Programme overview". The
detergent dispenser is located on the inside panel of the door.
To open the "
3"
cover on the dispenser, press the "
4"
button.
The detergent for the wash cycle should be poured into the "
5"
compartment.
The detergent for the pre-wash cycle should be poured into the
“
6”
compartment.
After the detergent has been placed in the dispenser, close the
cover and press down until it clicks in place.
L
oading the detergent
Notice:
To facilitate closing the cover, remove any excess detergent on the edges of the dispenser.
Dishwasher detergents are stronly alkaline. They can be extremely dangerous if swallowed.
Avoid contact with the skin and eyes and keep children away from the dishwasher when the
door is open. Check that the detergent receptable is empty after completion of the wash
cycle.
