8
Installation instructions
Fastening the installation brackets
Each cooktop is provided with two
R
type brackets (for the rear of the cooktop), two
F
type
brackets (for the front of the cooktop) and four screws for fastening the cooktop to benches from
20 to 40 mm thick.
1
Create a cutout according to the dimensions in Fig.2.
2
Stretch gasket “
D
” (Figs. 6 and 7) over the edge of the cutout, being careful to overlay the
junction edges.
3
Turn the cooktop upside down, place it on a soft surface and fasten the brackets
F
and
R
to the
appropriate socket holes, without tightening the screws
B
for the moment. Make sure that the
tabs are mounted correctly, as shown. Rotate the tabs so that the cooktop can be put into the
cutout.
4
Put the cooktop into the cutout and position it correctly.
5
Put the brackets
F
and
R
into place; tooth
A
of the brackets should go into the hole (Figs. 6 and
7).
6
Tighten screws
B
until the cooktop is completely secured to the bench.
7
Using a sharp cutter or trimmer knife, trim the excess sealing material around the edge of the
cooktop. Take care not to damage the workbench.
20
mm min.
40
mm max.
B
D
R
type bracket
A
20
mm min.
40
mm max.
B
D
F
type bracket
A
Fig. 6 Rear side
Fig. 7 Front side
Fig. 5 Fastening the
installation brackets
FRONT
F
F
R
R
B
