Haier HBS800, Service Manual, Page: 19 / 30

Front Load Washing Machine Model:HBS800/1000TXV
Page 18
Error message:The required water level is not reached within 8 min
Troubleshooting:
N
Check if inlet valve is jammed
Clean inlet valve
N
Draw out the dispenser and check if water is
entering
Observe if the height of
drain pipe not reach 80
cm. If water level
pressures switch and
the hose is leaking gas
N
Turn on power, and set pre-wash mode, then
start. Check the import voltage of
electromagnetic valve by multimeter,
is it between AC 220-240V?
Electromagnetic valve must be broken, please replace
it.
N
Check if tap is closed or water pressure is too
low (usual between0.2 -1 MPa)
Open the tap or wait for normal water pressure to use
The wire connected PCB and inlet valve is not
properly. Please reconnect it or replace it.
Y
Y
Y
Y
Y
Check if water is leaking from washer
bottom. inlet pipe. drain pipe or other
pipe connection
Y
Readjust or replace the broken parts
Replace PCB
N
N
Check if export voltage from PCB to
electromagnetic valve, is it between AC
220-240V?
220-240V