Installation
Installation
Waiting time
To the maintenance-free lubrication oil is located in the
capsule of the compressor. This oil can get through
the closed pipe system during slanting transport. Be-
fore connecting the appliance to the power supply you
have to wait 2 hours so that the oil runs back into the
capsule.
2 h
Aigning the appliance
The appliance should be placed on a flat and solid sur-
face.
1. Tilt the appliance slightly backwards.
2. Set the feet to the desired level.
Make sure the distance to the wall on the hinge side is
at least 100 mm for the door to open properly.
3. The stability can be checked by alternately bump-
ing on the diagonals. The slightly swaying should
be the same in both directions. Otherwise the
frame can warp; possible leaking door seals are
the result. A low tendency to the rear facilitates
the closing of the door.
max 45°
1.
2.
3.
WARNING!
To avoid risks a damaged power cord must be replaced by the customer service (see
warranty card).
Electrical connection
Before each connection check if:
▶
power supply, socket and fusing are appropriate to the rating plate.
▶
the power socket is earthed and no multi-plug or extension.
▶
the power plug and socket are strictly according.
Connect the plug to a properly installed household socket.
Door Reversibility
Before connecting the appliance to the power supply you should check, whether the door
swing must changed from right (as delivered) to left, if this is required by the installation
location and the usability.
WARNING!
▶
The appliance is heavy. You need two persons to carry out the door reversibility.
▶
Before any operation, first unplug the appliance from the mains .
▶
Do not tilt the appliance more than 45 ° to prevent damage of the cooling system.
1. Provide necessary tool.
2. Unplug the appliance.
3. Remove the fixation of the cover
4. Remove the faceplate of the body
5. Remove the topplate of the upper door.
6. Remove the hinge cover.
7. Unplug the connection cable
8. Unscrew the upper hinge.
9. Lift the loose upper door carefully off the lower
hinge.
10. Turn the upper door upside down and change the
position of the hinge barrel on the lower side of
the door.
11. Change the door stop from the current position
to opposite side
12. Unscrew the lower hinge of the upper door.
1.
2.
3.
4.
5.
25
6.
7.
8.
9.
10.
12.
11.
28
29
Summary of Contents for HBM450SA1
Page 1: ...User Manual Refrigerator Freezer HBM450WH1 HBM450SA1 ...
Page 17: ......
