adequately insulated.
The unit and the auxiliary drain pan must be adequately elevated to insure proper drainage.
ELECTRICAL CONNECTIONS
When an optional heat kit is installed refer to the electrical requirements in that kit.
The wiring diagram included in the heat kit must be placed over the wiring diagram on the air handler.
Air Handler as indicated.
Table
6
-
1
Electrical parameter
The required electrical power supply information is located on and rating plate on the exterior of the unit.
Copper wire is recommended for all electrical connections.
Wiring selection must be in accordance with local codes, or in absence of local code, the National
All pertinent information, such as the rating plate, included in the optional heat kit must be applied to the
Electrical Code. A disconnect means should be installed within sight of the unit, as required by code.
When copper tubing is uesed for the condensate line, adequate caution must be taken to prevent damage
to the plastic drain pan during the soldering process. All condensate drain lines and drain traps should be
Use of a condensate removal pump may be necessary. This condensate pump should have provisions
for shutting off the control voltage should a blockage in the drain line or condensate pump failure
contain any of these materials.
occur. A trap must be installed between the unit and the condensate pump.
Important:
The evaporator coil may have residual oils that could dissolve Styrofoam and certain types
of plastics. Therefore a removal pump or float switch must not
The use of copper connections are recommended for all modification or field supplied accessories inside
the air handler electrical section inside the control box.
Central Air Conditioning Model: Air Handler, HB-D series
15
Model(indoor units)
Min. ampacity
208/230V
Max.Overcurrent(A)
208/230V
Fan motor
capacitor(UF)
Blower motor
FLA
Blower
motor HP
HB2400VD1M20
1.1
15/15
8
0.9
1/8
HB3600VD1M22
2.5
15/15
8
2.0
1/3
HB4800VD1M22
3.3
15/15
8
2.6
1/2
HB6000VD1M22
4.4
15/15
12
3.5
3/4
HB6000VD1M22-E
5.0
15/15
/
4.0
3/4