Press MODE button. For each press, operation
Operation
(1) Unit start
mode changes as follows:
Press ON/OFF button, unit starts.
Previous operation status appears on display. (Not Timer setting)
(2) Select operation mode
Unit will run in operation mode displayed on LCD.
Stop display at your desired mode.
(3) Select temp. setting
Press TEMP button.
Every time the button is pressed, temp. setting increases 1
o
C
Every time the button is pressed, temp. setting decreases 1
o
C
Unit will start running to reach the temp. setting on LCD.
Press FAN button. For each press, fan speed changes
(4) Fan speed selection
as follows:
AUTO
LO
MED
HI
just press ON/OFF button and unit will run in previous status.
Unit runs at the speed displayed on LCD.
Hints
On cooling only unit, heating mode is not available.
Remote controller can memorize each operation status. When starting it next time,
COOL operation starts when room
temp. is higher than temp. setting.
Ultra-low air flow
Temp. 2
o
C
Temp. setting
On reaching temp. setting, unit
will run in mild DRY mode.
In DRY mode, when room temperature becomes
lower than temp.2
o
C,unit will run intermittently
at LOW speed regardless of FAN setting.
(5)
Unit stop
Press ON/OFF button, the unit stops.
Dry Operation
AUTO
COOL
DRY
FAN
HEAT
No reelecting is needed.(TIMER ON/OFF
ǃ
SLEEP
ǃ
SWING needs reelecting)
ON/OFF
MODE
SET
FAN
TIMER
SWING
CLOCK
SLEEP
LOCK
RESET
HEALTH
3
3
1
5
2
4
11
Summary of Contents for H2SM-
Page 99: ......
