2
FIELD SERVICE MODE ENTRY
Press and hold
Start
button while rotating the
cycle selection knob 180 degrees and then
release the
Start
button.
• Once service mode is entered all LEDs will
be flashing.
• The cycle selection Knob is now used to
control the test selection menu.
– Rotating the knob clockwise will increment
the test numbers in the
display.
– Rotating the knob counter-clockwise will
decrement the test number in the display.
– Turning the knob to go to a different test will
terminate any current active state
• Once the test number is selected, pressing
Start
will begin the selected test.
• Once the test number is selected, pressing
Start
will begin the selected test.
Exit Field Service Mode
• Field service mode will time out after 30 minutes
if there is no user activity.
• Press
Power
button
SERVICE MODE
TEST 17
-
Change Personality
Pressing
Start
will start the test. Press
Start
button again and the next valid personality should
be displayed. Press and hold the
Start
button to
select the correct personality. The control will go to
an idle state. All LEDs off.
Note:
If the personality ID is already set and you
try to set the same personality the control will
NOT go to an idle state. Ensure the correct
personality ID is being entered.
99-3000289