Haier DW12-EBM 3S, Instructions For Use Manual

Page: 17 / 27

16
A cycle that is underway can only be modified if it has been running for a short time. Otherwise, the
detergent may have already been used, and the appliance may have already drained the wash
water. If this is the case, the detergent dispenser must be refilled (see the paragraph entitled,
"Loading the Detergent").
When the buzzer constantly beeps six times, the “End” light will turn on and the cycle has finished. Turn off
the appliance using the ON-OFF button, turn off the water supply and open the door of the dishwasher.
Wait a few minutes before unloading the dishwasher to avoid handling the dishes and utensils while
they are still hot and more susceptible to breakage. They will also dry better.
Cancelling or modifying a wash cycle setting... Cancelling or modifying a wash cycle setting... Cancelling or modifying a wash cycle setting... Cancelling or modifying a wash cycle setting... Cancelling or modifying a wash cycle setting...
At the end of the wash cycle... At the end of the wash cycle... At the end of the wash cycle... At the end of the wash cycle... At the end of the wash cycle...
Rotate the knob to the mark of “Reset” then select
right programme.
Wash Cycle Adjustment Buttons Wash Cycle Adjustment Buttons
Wash Cycle Adjustment Buttons Wash Cycle Adjustment Buttons Wash Cycle Adjustment Buttons
"ECO" Button "ECO" Button "ECO" Button "ECO" Button "ECO" Button
This button (see "Close-up View - Control Panel", letter "A A A A A" ) is used for normal dirty dishes, pots and
pans.
“3 IN 1” Button “3 IN 1” Button “3 IN 1” Button “3 IN 1” Button “3 IN 1” Button
When using "3 IN 1"combination products, the rinse-aid and salt lights are no longer useful. It may be
helpful therefore to switch the rinse aid off (please note that only some dishwashers have this facility )
and selecting the lowest possible setting for water hardness.
If you decide to switch to the use of a standard detergent system we advise that you:
1:Refill both the salt and rinse aid compartments.
2:Switch the waterhardness setting to the highest possible position and run for three normal cycles
without a load.
3:Readjust the waterhardness setting again according to the conditions for your region (as per the in-
struction manual).
Notice Notice
Notice Notice Notice
Do not place the tablets in the tub or the cutlery basket as this will Do not place the tablets in the tub or the cutlery basket as this will
Do not place the tablets in the tub or the cutlery basket as this will Do not place the tablets in the tub or the cutlery basket as this will
Do not place the tablets in the tub or the cutlery basket as this will
result in poorer wash results. The tablets should be placed in the result in poorer wash results. The tablets should be placed in the
result in poorer wash results. The tablets should be placed in the result in poorer wash results. The tablets should be placed in the result in poorer wash results. The tablets should be placed in the
detergent doser. detergent doser.
detergent doser. detergent doser. detergent doser.
en
1
2
3
4
5
6
7