Serial Number: Version:00.00
Edition: 2005-7
Dishwasher
Model: DW12-CBE5/6
Page 5 / 21
4.Net dimension
5.Installation and Accessory Parts
5.1 Mounting the Wooden Panel onto the Door and Sliding the Dishwasher into the Cabinet
During the preparatory stages for installing the dishwasher into the kitchen cabinet, holes must not be drilled
in the sides, or door, in order to avoid compromising the performance and/or operation of the appliance.
Before working on any internal components, the unit must be disconnected from the power supply. The
maximum dimensions for the wood panel that can be installed on the door are: Height - 725 mm; Width
–
598
mm; Thickness:20 mm.
The height dimension of 610 mm must be reduced if the height of the control panel is increased through the
use of
5.2 Using the Drilling Template (Fig.3)
Align the top edge of the template (identified with the
“
A
”
arrow ) with the top edge of
the panel. On both sides of the template (top and bottom ) are written the various
dimensions that correspond to the different possible widths for the panel. Align the
template with the side of the panel (left or right), making sure that the panel
coincides with the appropriate dimensions. Mark the positions for the holes for the
screws, using the tip of a drill or a pencil. The three holes closest to the side should
be used(B). Repeat this step on the other side of the panel ,using the corresponding side of the template.
5.3 Fastening the Bracket to the Wooden Panel (Fig.5)
At the point marked, drill holes 2 mm in diameter. If the panel is made of chip board only
drill through the veneer. If the panel is made of solid wood, the holes can be made deeper.
Position the two brackets so that they are lined up with the holes made in the bottom part of
the panel. The holes furthest to the outside should be used to fasten the brackets. The small
fins should be turned downward. The hooks in the totally built-in version should be screwed
into the two holes at the top.
5.4 Mounting the Wood Door Panel onto the Dishwasher
Insert the top hooks into the appropriate slots in the dishwasher control panel. Then push
the panel upwards until it stops. Afterwards, slide the panel downward again, moving the
bottom of the panel toward the door so that the fins on the brackets slide into their slots
(Fig.8).
Open the doors of the dishwasher (the panel should stay in place by itself) and align the
panel with the door, keeping it in contact with the control panel. Remove the small plastic
plugs that cover the holes on the inside of the dishwasher door and fasten the panel in
place with the screws provided (Fig. 9).
Remember to cover the two holes with the plastic plugs removed earlier.
