Haier CGDE560BW, User Manual

Page: 20 / 106

18
STEP 2 - CONNECT TO A GAS SUPPLY LINE
(GAS DRYER ONLY)
NOTE: Do not connect the dryer to an LP gas line without Þ rst converting the
dryer with a conversion kit. An LP conversion kit must be installed by a quali Þ ed
technician.
NOTE: Apply a pipe-joint compound that that is resistant to the action of LP gas to
all males threads. Do not use plumber’s tape.
1. Turn the gas supply o by moving the shuto valve to the closed position.
Closed Valve
Open Valve
A
B
2. Disconnect and discard old ß exible gas connector. Replace with a new
CSA(AGA) approved ß exible gas connector.
3. Remove the shipping cap from the gas inlet pipe at the rear of the dryer.
4. Connect a ! " NPT elbow to the gas inlet pipe on the dryer. Then connect a ß are
adapter to the elbow.
IMPORTANT: Use a pipe wrench to keep the dryer gas inlet pipe from twisting.
Gas Inlet Pipe on
the Dryer
! " NPT Elbow
! " NPT Flare Adapter
A
B
C
5. Connect the dryer to the gas supply line with a ß exible gas connector.
Flexible Gas Connector A
6. Tighten the ß exible gas connector using two adjustable wrenches.