Haier AS50PDAHRA, Operation Manual

Page: 5 / 180

Parts and Functions
Indoor Unit
Remote controller
1
6
Inlet
Air Purifying Filter
(inside)
8. Additional functions display
Supplemented 2
Operation mode
QUIET SLEEP electrical HEALTH TURBO
heating
7
Remote controller
Display
3
Inlet grille
board
4
Emergency
5
8
Switch
9
18
10
Horizontal flap
(adjust up and down air flow
Vertical blade
11
19
(adjust left and
Don't adjust it manually)
20
right air flow)
Outlet
12
21
13
22
14
23
Display board
1
Signal receiver
2
Setting temp.display
15
24
1
16
17
25
2
1. Mode display
Function: Sleeping---- Healthy
airflow position1--- Healthy airflow
position 2 --- Turbo --- Air sending
--- A-B yard --- Left and right air flow
Operation mode
AUTO COOL DRY FAN HEAT
Remote controller
Display
Actual inlet grille may vary from the one shown in the
manual depending on the product purchased
circulated
LO MED HI AUTO
the remote.
Healthy function is not available for some units.
Outdoor Unit
Loading of the battery
1
Remove the battery cover;
2
Load the batteries as illustrated.
2 R-03 batteries, resetting key
(cylinder);
3
Be sure that the loading
is in line with th
e" + "/"-";
4
4
Load the battery,then put on the cover again.
Note:
The distance between the signal transmission head and the rece-
iver hole should be within 7m without any obstacles.
OUTLET
CONNECTING PIPING AND ELECTRICAL WIRING
DRAIN HOSE
When an electronic-starter type fluorescent lamp, change- over
type fluorescent lamp or wireless telephone is installed in the
room, the receiver is apt to disturb the receiving of signals,
therefore the distance to the indoor unit should be shorter.
Full display or unclear display during operation indicates the
INLET
Please note the above picture is for reference only.
This may very depending on the unit purchased.
batteries have been used up. Please change batteries.
If the remote controller does not operate normally during, please
remove the batteries and reload several minutes later.
Hint:
If the remote has not been used for a long period, change the
batteries and press the reset key.
9. QUIET button
10. HEAT button
11. COOL button
12. AUTO button
13. FAN SPEED button
14. TIMER button
15. HEALTH button
16. LOCK button
Used to lock buttons and LCD display
17. LIGHT button
Control the lightening and extinguishing
of the indoor LED display board.
18. POWER ON/OFF button
19. DRY button
20. TEMP button
21. SWING button
22. HOUR button
23. EXTRA FUNCTION button
2. Signal sending display
3. SWING display
4. FAN SPEED display 24.CANCEL/CONFIRM button
Function: Setting and cancel to the
timer and other additional functions.
25. RESET button
When the remote controller appears
abnormal, use a sharp pointed
article to press this button to reset
5. LOCK display
6. TIMER OFF display
TIMER ON display
7. TEMP display
2