Operation
Clock and Lock set
Note:
The distance between the signal transmission head and
the receiver hole should be within 7m without any obstacle
change-over wireless telephone is installed in the type
in receiving the signals, so the distance to the indoor unit
should be shorter.
Full display or unclear display during operation indicates the
batteries have been used up. Please change batteries.
If the remote controller can’t run normally during operation,
please remove the batteries and reload several minutes later
.
Hint:
Remove the batteries in case unit won’t be in usage for
a long period.
20. 10 ºC button
special heating set
function: 10 degree
heating maintaining
(valuable for RS)
18.
button
TIMER
23. SWING up/down button
24. SWING left/right button
19.
button
CLOCK
26. HEALTH AIRFLOW button
21. SMART HUMIDITY button
28. CODE button
A-b yard
29. APPLY button
30. LIGHT button
25. SLEEP button
19
20
21
22
23
24
25
26
27
28
29
30
18
22. SMART button
Used to set SMART
operation. (This function
is unavailable on some
models.)
27. AIR STATUS button
Control the lightening and
extinguishing of the indoor
LED display board.
Press CLOCK button,
Press “+” or “-” to set
correct time.
Each press will increase or
decrease 1min. If the button is
kept pressed, time will change
quickly.
press APPLY, “AM” and
starts working.
1
2
3
2
Press “
SMART HU“HEALTH AIRFLOW”
set and cancel the “LOCK”
function ( )
SMART
HUMIDITY
AIR
STATUS
AIR
STATUS
SMART
HUMIDITY
simultaneously can
