4. How to check the addresses?
When finish all the above works, please power off and power on again to the whole system but set all
the indoor units in STANDBY. Then continously press the emergency switch until you hear the buzzer
sound 5 times(Pi Pi Pi Pi Pi), and then the TIMER LED board will show the address of this indoor unit.
Press any key on the remote controller, it will exit the address checking precedure.
1 2 3 4 5 6 7 8
ON
OFF
SW01
SW03
INDOOR
UNIT ADDRESS
1
2
3
4
19
10.Setting method of temperature compensation (For heating function only)
In 24 C heating mode,press sleep 7 times continuously.Indoor buzzer sounds 2 times,that show temp.compensatoin
works.Swith on the unit in heating mode by the remote controller,press the time button to set the set temp. compensatoin.
so the set temp. compensation=the current set temp.-24 C.For example,if the set temp. is 24 C,the temp.compensation
is 0 C;if the set temp.is 25 C,the temp. compensation is 1 C;if the set temp.is 30 C,the temp. compensation is 6 C;if the set
temp.is 23 C,the temp. compensation is -1 C;if the set temp.is 16 C,the temp. compensation is -8 C;If setting is finished,
press ON/OFF button, then the unit quits the temp. compensation.
Set method of temperature compensation(-8 C~6 C) in heating mode with the remote controller.
1 2 3 4 5 6 7 8
ON
OFF
ON
OFF
1 2 3 4 5 6 7 8
ON
OFF
1 2 3 4 5 6 7 8
1 2 3 4 5 6 7 8
ON
OFF
Instructions to installation
