Haier A3FE737CPJM, User Manual

Page: 26 / 110

9- Troubleshooting
EN
Problem Possible Cause Possible Solution
The compressor
does not work.
•
Mains plug is not connected in the
mains socket.
•
Connect the mains plug.
•
The appliance is in the defrosting
cycle.
•
This is normal for an automatic
defrosting.
The appliance runs
frequently or runs
for a too long pe-
riod of time.
•
The indoor or outdoor tempera-
ture is too high.
•
In this case, it is normal for the ap-
pliance to run longer.
• The appliance has been off power
for a period of time.
•
Normally, it takes 8 to 12 hours for
the appliance to cool down com-
pletely.
•
A door/drawer of the appliance is
not tightly closed.
•
Close the door/drawer and ensure
the appliance is located on a level
ground and there is no food or
container jarring the door.
•
The door/drawer has been opened
too frequently or for too long.
•
Do not open the door/drawer too
frequently.
•
The temperature setting for the
freezer compartment is too low.
•
Set the temperature higher until a
satisfactory refrigerator tempera-
ture is obtained. It takes 24 hours
for the refrigerator temperature
to become stable.
•
The door/drawer gasket is dirty,
worn, cracked or mismatched.
•
Clean the door/drawer gasket or
replace them by the customer
service.
•
The required air circulation is not
guaranteed.
•
Ensure adequate ventilation.
The inside of the
refrigerator is dirty
and/or smells.
•
The inside of the refrigerator
needs cleaning.
•
Clean the inside of the refrigera-
tor.
•
Food of strong odour is stored in
the refrigerator.
•
Wrap the food thoroughly.
Many occuring problems could be solved by yourself without specific expertise. In case
of a problem please check all shown possibilities and follow below instructions before you
contact an after sales service. See CUSTOMER SERVICE.
WARNING!
▶
Before maintenance, deactivate the appliance and disconnect the mains plug from
the mains socket.
▶
Electrical equipment should be serviced only by qualified electrical experts, because
improper repairs can cause considerable consequential damages.
▶
A damaged supply should only be replaced by the manufacturer, its service agent or
similarly qualified persons in order to avoid a hazard.
26
9.1 Troubleshooting table