HAI 86A00-2, User Manual

Page: 2 / 7

Page 2
RS232 Port: Standard serial communications for bi-directional control. Bauds are available from 300 through 115200.
I/O Ports: The 2 I/O ports can be configured to act as a digital input or a digital output. For use with voltage and current sensors to
detect the power state (on/off) of a device. Digital outputs are rated for 10mA at 3.3VDC.
Relay Ports: The 2 Form-C relays allow control of any device which requires a contact closure, like a motorized screen or blinds.
They can also source and switch 12VDC for power amplifier triggers. The relays are rated at 2A at 30VDC.
12VDC: This is a general purpose 12VDC voltage output that can be used to power a device or sensor that is rated up to 250mA.
IR Emitter: Connect the 3.5mm connector for each of the supplied IR flashers to the IR Emitter jacks on the HTX2. The IR flasher is
used for sending IR data to control IR equipment.
IR
SOURCE EQUIPMENT
(FRONT)
IR RECEIVER
WINDOW
IR FLASHER
IR Learner: The IR Learner is a built-in IR receiver that is used to add custom IR codes to your Automation Studio IR Library.
GND RS-232 Ground
RXD RS-232 Receive Data
TXD RS-232 Transmit Data
IO 1 Can be configured as a digital input or digital output
GND Ground
IO 2 Can be configured as a digital input or digital output
GND Ground
R1 NC Relay 1 Normally Closed: Connected to R1 Common when Relay 1 value is “0”
R1 C Relay 1 Common
R1 NO Relay 1 Normally Open: Connected to R1 Common when Relay 1 value is “1”
R2 NC Relay 2 Normally Closed: Connected to R2 Common when Relay 2 value is “0”
R2 C Relay 2 Common
R2 NO Relay 2 Normally Open: Connected to R2 Common when Relay 2 value is “1”
+12DC General purpose voltage output, + 12VDC, 250mA maximum
IR 1 – IR 4 IR Emitter Ports 1-4: Accepts standard 3.5mm tip-positive IR emitters
IR 5 LEARN IR Receiver: Infrared learner target
Connect to IR Emitter (IR 1 – IR 4) on the HTX2