Page 2
INSTALLATION REQUIRMENTS
•
The controller must have Version 1.5 or later firmware for Omni-Link, Version 1.6 or later for Pro-Link.
•
For connections to a personal computer, use a standard "data transfer" or "null modem" cable, with a DB-9F (female) connector
on the end going to the Serial Interface, and either a DB-9F or DB-25F, depending on the application, to the personal computer.
•
For connection to an external, auto answer modem, use a standard "modem" cable, with a DB-9F connector for the 10A17 Serial
Interface and a DB-25M (male) for the modem.
•
If cables are not long enough, or will be installed in the walls, you can make a cable using the diagrams in Figure 3.
INSTALLATION
1.
Power down the controller by disconnecting the 24 VAC transformer and the battery.
2.
Remove 4 6/32 x 1/4 Phillips screws marked "A" in Figure 1. Retain screws for future step.
3.
Connect supplied cable to 20 pin connector (J3) on controller marked "B" in Figure 1, or to open 20 pin connector on current
module installed on controller.
4.
Install the 4 supplied 6/32 x 3/4 male/female Hex spacers in holes where screws were removed, marked "C" in Figure 2.
5.
Place 10A17 on top of the controller. Line up mounting holes marked "D" with Hex spacers marked "C" in Figure 2.
6.
Reinstall 4 6/32 x 1/4 Phillips screws through mounting holes "D" in 10A17 Serial Interface into Hex spacers "C" on controller as
shown in Figure 2.
7.
Connect opposite end of supplied cable to the connector (J1 or J2) directly above on the 10A17 marked "E" in Figure 2.
8.
Set the ADDR (address) jumper "F" on the serial interface as described under
JUMPER SETTINGS
.
FIGURE 1
FIGURE 2
